IC200GBI001-FG interfaces a VersaMax I/O station to a Genius I/O bus. The system host can be a PLC or computer capable of controlling the Genius bus.

The Genius NIU can handle up to 128 bytes of discrete and analog input data and 128 bytes of discrete and analog output data per bus scan. A station can use up to eight modules per rack and up to eight racks.

Need the Exact -FG Revision?

Send the complete part number and your installed network type when requesting a quotation. This helps reduce the risk of selecting a visually similar but functionally different VersaMax network interface.

IC200GBI001-FG is the Genius network interface for a VersaMax I/O station. It belongs on a Genius bus architecture, whereas the Ethernet and PROFINET interface modules serve different network paths.

The -FG revision corresponds to firmware 2.30. Later IC200GBI001 revisions introduced additional hardware or firmware changes, so the full suffix should be preserved when matching an installed system.

The Genius NIU supports 128 bytes of input data and 128 bytes of output data per bus scan. The VersaMax station can contain up to eight modules per rack and up to eight racks.

Yes. The VersaMax Genius NIU can operate with a host capable of controlling the Genius bus, and the supported controller families include PACSystems RX3i and RX7i as well as Series 90-70.

Confirm the complete -FG part number, Genius bus arrangement, serial bus address, baud-rate setting, station module order, power supply configuration and the intended host controller. These details determine whether the replacement matches the installed architecture.